⚙️Electric Adjustable Motorcycle Plate Bracket – Up to 160° Motorized Angle Control
⚙️Electric Adjustable Motorcycle Plate Bracket – Up to 160° Motorized Angle Control
BUNDLE & SAVE
Couldn't load pickup availability
-
Ordered
- - -
Order Ready
- - -
Delivered
⚙️Electric Adjustable Motorcycle Plate Bracket – Up to 160° Motorized Angle Control
Motorized Adjustable
License Plate Bracket
Add clean, button-controlled plate-angle adjustment to your motorcycle with a compact motorized bracket, slotted mounting points and an integrated wired control system.
Change the Plate Angle Without Reaching Behind the Bike.
The built-in motorized pivot allows the bracket angle to be adjusted using the wired control button instead of manually repositioning the plate holder.
One Button. No Manual Repositioning.
Mount the supplied control button in a safe, convenient position within reach of the rider. The example installation places it near the left-side handlebar controls.
Measure Your Mounting Hole Spacing.
140–183 MM Approx. 5.5–7.2 in Mounting Hole SpacingThe product image specifies an adjustable mounting-hole range of approximately 140–183 mm. Measure your motorcycle's mounting points before ordering and confirm adequate space around the rear wheel, lighting and bodywork.
Secure the Bracket Before Wiring.
Position the mounting plates on the motorcycle's rear mounting area, align the slotted holes, and tighten the hardware securely. The supplied reference image shows the mounting bolts installed in offset positions to maintain clearance between the two plates.
Understand the Connections Before You Start.
The motorized bracket connects to the supplied control wiring, control button and motorcycle power source. Lay out the harness first so every connector and cable route is clear before final installation.
Keep the Wiring Inside the Motorcycle's Natural Cable Path.
Start at the rear bracket, guide the motor cable into the bodywork, continue beneath the seat and route it forward along the motorcycle frame.
Rear Cable Entry
Guide the bracket cable safely into the motorcycle bodywork.
Under-Seat Route
Follow existing frame and wiring paths whenever practical.
Route Forward
Continue toward the front while maintaining safe clearance.
Keep the Button Accessible & the Cable Secure.
Mount the control in a safe position within reach, then secure loose wiring along the motorcycle with appropriate cable ties.
Verify Polarity Before Powering the System.
The supplied wiring references identify the red lead as positive (+) and the black lead as negative (−). Disconnect motorcycle power before making electrical connections.
Confirm positive and negative polarity before applying power. Incorrect wiring can damage electrical components. If you are not comfortable with motorcycle electrical work, installation by a qualified technician is recommended.
Compact Hardware. Clean Rear-End Fit.
Once mounted and wired correctly, the compact bracket integrates into the rear of the motorcycle while keeping the adjustment mechanism close to the original plate position.
Motorized Pivot + Slotted Mounting Plates.
The central motorized assembly connects the upper and lower mounting plates, while elongated slots provide adjustment within the specified mounting-hole range.
Use the Adjustable Function Responsibly.
License-plate mounting and visibility requirements vary by location. On public roads, always keep your plate positioned, illuminated and visible as required by applicable local law.
Installation FAQ
What mounting-hole spacing does the bracket support?
How is the bracket adjusted?
Where should the control button be installed?
How should the cable be routed?
Which wire is positive and negative?
Can I use the bracket on public roads?
Upgrade the Rear of Your Motorcycle Without a Messy Setup.
A compact motorized pivot, adjustable mounting slots, dedicated control button and integrated wiring system come together in one streamlined rear-plate bracket setup.
