Leave the chill at the doorstep.
Feel cold air around your ankles even after you close the door? A flexible silicone edge covers the gap underneath, helping your entryway feel cozy again.
Less grit on the floor you just swept.
A breeze can carry dust and little bits of dry leaves under a closed door. Covering that opening gives them one less way onto your entry rug.
Measure before you peel.
With the door closed, check the gap and the flat surface above it. The adhesive needs room to sit flat while the flexible edge overlaps the opening.
- Full strip width
- 1.77 in.
- Length per roll
- 16.4 ft.
A pair of scissors gets you started.
Wipe the mounting surface clean and let it dry. Hold the strip in place with the liner on and check that the door opens and latches freely.
-
Trim to length
Measure the edge you want to seal, then cut a matching piece from the roll.
-
Start at one end
Peel back a little liner. Line up the exposed end before uncovering the rest.
-
Press as you go
Smooth the adhesive band onto the surface as you peel. Open and close the door to check the fit.
A subtle finish for the places you love.
Along painted trim
The frosted edge sits close to the door, letting the color and woodwork stay in view.
Beside the window seat
Feel a breeze by your favorite chair? Cut a piece for the drafty window seam, leaving the sash free to move.
What’s on the roll
- Material
- Flexible silicone rubber
- Roll length
- 5 m (about 16.4 ft.)
- Total width
- 45 mm (about 1.77 in.)
- Mounting
- Peel-and-stick adhesive on one edge
- Suitable surfaces
- Smooth, clean, dry areas on doors, window frames and cabinets
A few questions about fit
How much of the roll will my door use?
A 36-inch door bottom takes 3 feet of strip. For more than one edge, add their lengths together and allow a little extra for trimming. Each roll gives you about 16.4 feet.
How low should the strip sit?
Hold it against the closed door before you peel. The flexible edge should overlap the gap without catching as the door swings. If it drags, adjust the position and test again.
Will it stick to rough trim?
The adhesive needs a smooth, clean, dry surface. Check for a flat area where the full adhesive band can make contact from end to end.
Start with the door you use every day.
Think of the spot where you kick off your shoes and feel that first little chill. Measure that edge and choose how many rolls you need.
